Kwikset SmartCode 260 Factory Reset Guide

If your Kwikset SmartCode 260 isn’t working properly, or you’ve moved into a home where the lock was previously used, performing a factory reset is often the best solution. A factory reset removes all existing user codes and restores the lock to its default settings, allowing you to set it up from scratch.

In this guide, I’ll show you how to factory reset the Kwikset SmartCode 260 and reprogram the lock.

Video tutorial:

How to Factory Reset the Kwikset SmartCode 260

1. Go to the interior side of the lock and locate the battery cover. Slide it upward and remove it to access the programming button.
2. Press and hold the programming button for 15 seconds.
3. Continue holding the button until you hear a long beep.
4. After hearing the long beep, release the programming button and press it once more.
5. The lock will reset to factory defaults.

Door Handing Detection

After every factory reset, you must run the door handing detection process. This allows the lock to learn the orientation of your door and determine whether it is left-handed or right-handed.

1. Press the Programming Button once.
2. On the keypad, press 0.
3. Press the Lock Button.
4. The deadbolt will automatically extend and retract.
5. Once the movement stops, the door handing process is complete.

Adding a User Code

The Kwikset SmartCode 260 allows you to create up to 50 user codes.

To Add a New Code:

1. Press the Programming Button.
2. Press 1.
3. Press the Lock Button.
4. Enter a new code (4-8 digits).
5. Press the Lock Button again.
6. If successful, you’ll hear a long beep and see a green flash on the keypad.

You can repeat the steps to add more User Codes (up to 50 codes).

Test the New Code

• Press the Lock Button to lock the door.
• Enter the new user code.

The lock should unlock, confirming that the code was added successfully.

Deleting a User Code

If you no longer want a code to work, you can remove it from the lock.

1. Press the Programming Button.
2. Press 3.
3. Press the Lock Button.
4. Enter the code you want to delete.
5. Press the Lock Button.
6. Enter the same code again.
7. Press the Lock Button once more.
8. A long beep and green flash will confirm that the code has been deleted.

Verify the Code Has Been Removed

• Lock the door.
• Enter the deleted code.
• The lock should not open.
• You can then test an active code to confirm that other user codes still work as expected.

Final Thoughts

Resetting the Kwikset SmartCode 260 is a straightforward process that can solve many lock-related issues.

After resetting the lock, don’t forget to perform the door handing process, create new user codes and test them.